May 02, 2016
09:33 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 02, 2016
09:33 AM
There comes the error: Pin Error: (P1[3] has been reserved for debugging in the DWR System settings).
What do I have to change on my project to use this pin like a normal GPIO? And where?
Solved! Go to Solution.
Labels
- Labels:
-
PSoC 5LP
1 Solution
May 02, 2016
10:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 02, 2016
10:20 AM
Click on the .cydwr file and under System tab change from 5 wire debug to Serial Debug and that will remove the issue.
1 Reply
May 02, 2016
10:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 02, 2016
10:20 AM
Click on the .cydwr file and under System tab change from 5 wire debug to Serial Debug and that will remove the issue.