BLE_UART in deepsleep mode with lowest connection interval

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

Hello,

   

I am new to PRoC BLE, so confusion abt Deepsleep mode and connection interval parameter. I am referring following project http://www.cypress.com/blog/100-projects-100-days/project-020-uart-ble-bridge

   

I am keeping connection interval min 7.5ms, max 10ms, latency 0 and connection timeout 4sec in this project, to do the fastest data transfer. I have measured current consumption is abt 5mAmp, either it transfers data or not. I am trying that system stay in deep sleep mode, when there are no data. But due to the lowest connection interval, system is waking up at every (7.5+10)/2 ms. So is there any possibility to avoid connection event? I can not use latency parameter, because if data is available then I want to transfer it immediately.

   

Any suggestions are appreciated.

0 Likes
1 Reply
Anonymous
Not applicable

Hi,

   

I am using CYBLE 022001 module with BLE Pioneer Kit 042.

0 Likes