Welcome in the forum, Dirk!
A fading LED might be a power problem (shortcut??). Can you verify that your BLE module is perfectly seated in the connectors.
The green LED shows the status of the Kitprog on your BLE Pioneer kit.
Do you have a chance to measure the voltage on the board using a multimeter?
PS: Where in Germany are you located? I live near Bremen.
input voltage 4,8V and the 3,3V are stable too. The Power LED doesen`t fade. Only the green status LED. It looks like a defined system state but i can`t find one with a fading LED. If I push the reset button while powering up the system i can start the Bootloader state.
The kit is detected as a mass storage from Windows... Are there known cases with corrupted file systems? Windows or Kit?
Im located in Stuttgart but born and grown up in Lübeck/Bad Schwartau.
Press the reset button for > 5s
I could swear i tryed this. ;-) THX!!!