8 Replies Latest reply on May 2, 2016 10:55 PM by user_1377889

    Low Initial Drive State for PWM components

    user_385543602

      Hi,

         

      I have a PWM connected to a high power LED, and want it's pin state to be low on startup.

         

      The problem is that I cannot set it low, as the initial drive state is grayed out in the configuration window.  There is a visible flash on startup because of this.  

         

      Is there I way that I can change this?  Maybe disconnect the pin through software somehow until I am able to set the PWM low?

         

      Thank you,
      Tom