1 Reply Latest reply on May 20, 2016 1:48 PM by rich.soennichsen_1592346

    Rejecting Connections When the Battery is Low

    rich.soennichsen_1592346

      My application will use a rechargeable battery.  I will let it run down to 2V or so before I need to reject connections until it charges back up.  I can continue advertising because that has some value and does not effect charging much.

         

       

         

      My battery voltage is measured by an external microcontroller which can set a pin on the BLE IC or it can send a command via I2C.

         

       

         

      How can I reject BLE connections during "run time"?  Can I read the "no conection signal" via I2C and then disallow connections?

         

       

         

      Thanks

         

       

         

      Rich