1 Reply Latest reply on Jun 19, 2016 11:46 PM by ajai

    How to use EZ-USB FX2LP CY7C68013A to write 4mb SOP8 mxic 25L3206E serial flash chip

    rmg.hrr

      Hi

         

      I would like to know how can I flash this MXIC 25L3206E chip using cypress board

         

      will direct connection to the chip pins vcc, gnd, pin 5(Data in/out) and pin 6(clock) would be enough from FX2LP board pins

         

      vcc, gnd and SDA and SCL 

         

      or there is any other connections required like write enable etc?

         

       

         

      Also what software required? I have USB control center installed and device is recognizes and i see it over in tree.

         

      Thanks