Anonymous
Not applicable
Jun 15, 2016
03:35 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 15, 2016
03:35 AM
Hi
I am building a project in which I go into deepsleep, wakeup upon a slow advertisement of 4000ms, take an adc sample and save an average to flash every 15 samples.
My issue is that following writing to flash the BLE module isnt waking up from deepsleep after 4 seconds anymore.
I understand that writing to flash affects the clocks and so I have called CyBLE_Stop() and CyBle_Start(StackEventHandler) before and after writing to flash.
I'm also concerned that the clocks are not being reinitialized following the flash write which could cause issues waking up on a BLE stack event.
Labels
- Labels:
-
BLE
1 Reply
Anonymous
Not applicable
Jun 16, 2016
10:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 16, 2016
10:09 AM
Hi,
We need to review your firmware for further analysis.
Please create a Tech Support case with us.
Regards,
- Madhu Sudhan