Anonymous
Not applicable
Jun 14, 2016
04:52 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 14, 2016
04:52 AM
I want to use the FX3 superspeed explorer board in a design. But I want to power the FX3 IO from the board that the exploder is plugged into. So the VBUS would come from the USB connector and the IO from the motherboard. But there could be a situation where the IO voltage is turned off but the VBUS would still be on from the connector. So is it OK to do this?
Thanks
1 Reply
Anonymous
Not applicable
Jun 15, 2016
10:24 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 15, 2016
10:24 PM
Hi,
Yes it is fine to do it.
Regards,
- Madhu Sudhan