Jun 15, 2016
09:18 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 15, 2016
09:18 AM
I just upgraded PSOC Creator 3.3 to CP3 (3.3.0.9604) and now I get the following error for two pins:
"Pin Error: (USB pins only support the drive modes 'Open Drain, Drives Low, and 'Strong Drive')"
I'm using the CY8C5888LTI-LP097 and the two pins in question are P15[6] and P15[7]. I would like these pins to be inputs. The previous version of Creator didn't complain. What's going on? Can I use these pins as inputs?
Labels
1 Reply
Jun 15, 2016
10:06 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 15, 2016
10:06 AM
Jfix: those pins are used by the USB kitprog and can not be set to inputs. The program checks for this and will not let you use it.