Attachments are accessible only for community members.
Anonymous
Not applicable
Jun 22, 2016
08:44 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 22, 2016
08:44 AM
Hello,
For one of our project, we are keen to use the FX3 chip and the GPIF engine to send/receive data on two parallel bus.
My question is as follow: is it possible to create a 24 bits data bus and use the 12 lower bits (from 0 to 11) to push data on bus and use the 12 upper bits (12 to 23) to retrieve data from bus ? The idea is to use the GPIF as an aggregator of the two concurrent 12 bits data path through a single USB port.
Best regards,
2 Replies
Anonymous
Not applicable
Jun 22, 2016
10:29 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 22, 2016
10:29 PM
No, This idea of two concurrent data path through a single USB port is not possible using FX3.
More specifically simultaneous IN_Data and DR_data is not possible using FX3.
Anonymous
Not applicable
Jun 23, 2016
12:25 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 23, 2016
12:25 AM
Hello,
Thank you for your quick reply.
Best regards,