1 Reply Latest reply on Jul 4, 2016 1:36 PM by userc_39921

    SRAM -> DMA -> FIFO(UDB datapath)

      I would like to copy SRAM data via DMA to the datapath FIFO. I am using the Datapath configurator. I want to use the FIFO F0.


      So my plan was to use the f0_bus_stat signal to trigger the next DMA transfer if the FIFO is not full. The DMA is outside of this component.


      I defined an output FIFObus_stat and mapped the signal f0_bus_stat to it -> ERROR invalid identifier


      So what's the correct name of the f0_bus_stat signal?




      Is there an example available that just shows what i want to do?