2 Replies Latest reply on Jul 27, 2016 2:46 AM by 18364551326_1671111

    Problems  about the communication between USB  and FPGA

    18364551326_1671111

      Hi:

         

        I have several problems about FX3, when I use the usb3014 transfer data with FPGA. I use the sync slave fifo mode to communicate with the FPGA , problems as following:

         

        First, transfer data from PC to FPGA. When the clk of FPGA lower than 80MHz ,the data will be stopped  to transfer.But when I click the rest of FPGA it will be continue to transfer.

         

       Second, data from FPGA to PC. When the clk of FPGA higher than 70MHz, the access of transfer will be stoped.Then I must to restart the power the device.

         

       The last one,it is also the must important one.Once I find when the transfer stopped ,the endpoints(in/out) of the USB device will be dropped. It looks like the user didn't download the firmware. 

         

       

         

       Does anyone ever meet this issue ?Is there any explanation to that ?

         

       

         

          Thanks for any returns