Anonymous
Not applicable
Jul 24, 2016
02:23 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 24, 2016
02:23 AM
Hi all,
Is there any SPI master ( UDB mode ) example codes that illustrates how to use multiple slaves with it ?
4 Replies
Jul 24, 2016
03:30 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 24, 2016
03:30 AM
The selection works in hardware via the ss-line. Have a look into SPIM datasheet page 4.
Bob
Anonymous
Not applicable
Jul 24, 2016
03:41 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 24, 2016
03:41 AM
yes I did proceed with that step ( using control register), but unfortunately not even obtaining the clock in the slave device.
Jul 24, 2016
04:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 24, 2016
04:00 AM
Wrong pin for clock? Bypassed with a cap? What underlying hardware are you using?
Bob
Anonymous
Not applicable
Jul 24, 2016
04:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 24, 2016
04:02 AM
The SPI ( SCB mode ) seems to work fine with it.
Using a customboard developed.