1 Reply Latest reply on Aug 1, 2016 12:11 AM by bmah

    CAN controller in MB9BF506NABGL


      For the CAN controller in MB9BF506NABGL I want to use the same 11 bit id (NMT_NODE_GUARD_ID   1792 ) as  TX and as a RX


      In my case RX works until I send on the same id from MB9BF506NABGL  (NMT_NODE_GUARD_ID   1792 ), then RX stops working for this id.


      I seems like I'm overwriting the RX setup registers when I send on the same Id


      How is best to set the CAN controller registers to get this working ?