2 Replies Latest reply on Aug 11, 2016 5:59 PM by george.gz

    How to hold the cpu reset for fx3 ez-usb when downloading firmware

    george.gz

      Hi,

         

      I'm looking for the method to download firmware to ez-usb fx3. And I found vendor command 0xA0 can be used.

         

      But fx2 spec says CPU must be hold in reset when downloading firmware(writing to 0xE600).

         

      Should CPU be hold for fx3 when downloading firmware? If yes, how to do?

         

       

         

      Thanks!

         

      George