- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am trying to set up a new project with the PRoC CYBLE-022001-00 and use 8 single ended analog channels. In PSoC Creator I get a 'M0003' error that 'analog channels can not be routed' (or similar). I am using a SAR ADC and it is set to 8 single ended channels. I see in the spec sheet that 8 single ended ADC channels are supported. What have I overlooked/not understood? thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you please post your complete project, so that we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file. This would ease the checking for us.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Frederick! I am sorry to tell you this is a mistake in the datasheet. You will be able to use only upto 4 single-ended channels with the SAR ADC. In some cases, when the Analog MUX Bus is not used, you might be able to use 6 channels. Thanks for bringing this into our notice!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ok, I think I can get away with just 6 x single ended channels. thanks!