1 Reply Latest reply on Sep 13, 2016 8:47 PM by bytetrailltd_1720806

    Bricked my PRoC with Deep Sleep sample code?




      I have a custom pcb with the PRoC BLE and so far so good... I can debug and program with the MiniProg3 attached via the 5 ways connector.


      I just tried the sample code in Cypress AN92584 with this switch set DEEPSLEEP_ONLY... This is supposed to give a good idea about deep sleep current consumption and current leakage. Since I did program this simple app, PSoC Creator doesn't see the target... so I can't program it anymore.


      Is there a way to retrieve control of the target? Have I bricked this device?


      Any help appreciated...