- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
As increasing of production quantity, we need to make programming of CYBLE-012011-00 on board with higher efficiency. We are now in system programming CYBLE-012011-00 using CY8CKIT-042. So the first idea is to get CYBLE-012011-00 preprogrammed before it is mounted on PCB, but I did not find any information on this from web. Could you shed some lights? Thanks.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for the suggestion.
Since the PCBA in total is simple so ICT test is not considered. So the question still is whether CYBLE-012011-00 can be bought pre-programmed? Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I would suggest you to get in contact with Cypress directly: At top of this page select "Design support -> Create a Support Case" and ask your question. You will be helped by a Cypress engineer.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you, Bob.
Already submitted Support Case. Will share back once got anwsered.