Thank you. I have one more question.
I found the mentioning of the input tolerance of GPIO_OVT pins in the 'Hot Swap' section.
Does this mean that the pin must be 'Hot swap' enabled and mapped to any of the GPIO_OVT pins (P5.0 or P5.1) for it to be 6V tolerant? Just want to make sure.
Please refer Pg:37 of the component datasheet.
A GPIO_OVT pin is used if any of the following parameters is set.
□ Hot Swap is set to true
□ Slew Rate is set to I2C FM+, or I2C HS
□ Drive Current is set to 10mA sink