- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have a time of 500ms between reset and calling the main function. It is the function in start_c init_libc_array taking all this time? How to reduce this time?
I created a test project for moving only one output to test this time.
Thank you,
Eric
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
All the programming of the internal registers which include components and wiring is done after stabilization of the clocks and PLL. All registers get a value, so setup time is independent of the components used,
In cydwr-file, System tab there is a "Device Configuration Mode" setting which allows for using more flash but faster setup.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
All the programming of the internal registers which include components and wiring is done after stabilization of the clocks and PLL. All registers get a value, so setup time is independent of the components used,
In cydwr-file, System tab there is a "Device Configuration Mode" setting which allows for using more flash but faster setup.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thank you for your help, I'll try.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks Bob,
I disable the WCO clock and now I have 5ms between reset and the main function.
Thank you again for your help.
Eric