2 Replies Latest reply on Sep 30, 2016 7:40 AM by user_242978793

    UART to Bridge help

    jeff.jacobson

      I am currently working with the UART to bridge example but need help being able to set and clear a pin to control the direction of my RS485 half duplex chip. Its not obvious where the correct place would be to do this. Has anybody done this before? Need to be able to raise the pin and then send out the complete message and then clear the pin.

         

      Maybe there is a better example then the UART to bridge code?

         

       

         

      Any help would be greatly appreciated. I am using the BLE dongle and pioneer kit with the red module plugged in but I don't think that matters.