4 Replies Latest reply on Oct 17, 2016 11:44 PM by anks

    USBUART Parity

    nferrini_1662991

      Hi everyone,

         

       I have implemented a USBUART on my CY8CKIT-059 Kit everything works properly but I would change the parity and the stop bit of trasmission

         

      Could someone tell me where I can set the UART's parameters?

         

      Thanks

        • 1. Re: USBUART Parity
          user_1377889

          Welcome in the forum!

             

          Only the windows host is able to set the datarate. Because the com port is only emulated, there is no real baud rate in that communication. There is a configuration setting program from Cypress:

             

          USB-Serial Configuration Utility
          Cypress USB-Serial Configuration Utility is an application included in the USB-Serial software development
          kit (SDK) installation. This utility is used to configure the USB-Serial device configuration,
          and helps use additional capabilities of USB-Serial device such as USB-UART configurations, USBGPIO
          controls, and custom development using the USB-I2C and USB-SPI protocols.
          After you install the USB-Serial SDK, click Start > All Programs > Cypress > Cypress
          USB Serial > Cypress USB-Serial Configuration Utility to launch the USB-Serial Configuration
          Utility.

             

           

             

          Bob

          • 2. Re: USBUART Parity
            nferrini_1662991

            Thank you for your disponibility
            Nicola

            • 3. Re: USBUART Parity
              nferrini_1662991

              Hi,

                 

               I tried to follow your suggestion... I installed the Utility but when I launch it I can't Connect any devices.

                 

              In the Start Page of Utility there is a list of components (CY7C.....) I use CY8C, it can be this the problem?
              If Yes, how can I change the parity of the USBUART?
              Thanks

              • 4. Re: USBUART Parity
                user_49271930

                USBUART is a slave.
                It has  function  uint8  USBUART_1_GetConfiguration(void) 
                but it does not has function SetConfiguration
                Bob said that Only the windows host is able to set the datarate.
                those. configuration (parity) can only change the master (PC) but not PSoC
                Yes?

                • 5. Re: USBUART Parity
                  anks


                  CDC Class Request are the requests supported by the USBUART component. If a request is not
                  supported, the USBUART component responds with a STALL, indicating a request error.

                     

                  There is a  CDC Class Request available as SET_LINE_CODING which allows the host to specify typical asynchronous line character
                  formatting properties such as: data terminal rate,number of stop bits, parity type and number of data bits. It applies to data transfers both from the host to the device and from the device to the host.

                     

                  So, host can change the  value of parity and stop bits, USBUART component cannot.