I cannot find an "LM35 pin" on the PSoC4 Pioneer BLE board. Can you be a bit more specific?
I want to connect LM35 externally on to the cy8ckit-042 BLE. Can I know the steps to configure LM35 externally on to the board and read the analog values using the serial.
Read the LM35 data sheet - it shows you the connection that need to be made for the sensor. Then look at the PSoC ADC component data sheet, which explains how it works. There are also example projects available for the ADC.
Basically you run the LM35 with the Vcc of the BLE board, and connect Vout to an analog input pin of the PSoC BLE (which one this is is configured in the project itself).
I would like to know the connection for ADC for external interface . I want to connect LM 35.
Please provide the connection CY8ckit-042 BLE.
Welcome in the forum.
Keep to the steps hli supplied in a former post. There are no fixed connections for ADC, you have to specify the pis yourself.
Did you already install Creator 4.0 and your kit files?
Could you please go through this example project. (https://www.hackster.io/22026/temperature-sensor-thermistor-psoc-2241ec) The project is based on CY8CKIT-059. But this should be helpful.