- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am trying to configure an I2C on the baseboard (CY8CKIT-042 -BLE) and need to check that on LCD.I am using CY8C4247LQI-BL483 which is an example code from the PSoC 4.
LCD simulation is not working on I2C " Can you provide some steps for this "
The below attached is the code and I have read the datasheet regarding the example program and when I tried doing it with the SW2 which is on the baseboard,but it also didn't work.If I have to configure the switch SW2 from software only how we have to do that ? Can I know where I am missing.
Srujani
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What is the LCD module you are using? (Link to datasheet)
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi
I am using character lcd with i2c interface.can you please share the link where i can find some videos for this.
thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
LINK to datasheet is missing
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Probably we both are a bit off track due to language barrier.
You are using a PSoC4 BLE
You configured an I2C LCD component (that is software)
You need to connect a real I2C LCD module (that is hardware) to your PSoC
There is no "LCD simulation", so you will need to buy a real I2C LCD module. When you have got one, I would like to have a link to its datasheet.
Bob