7 Replies Latest reply on Mar 11, 2017 10:25 AM by hschnied_1648561

    ProximityGesturesWithBLE - Unsuccessful - Requesting Help

    cw_2000876

      Hello,

         

      First off, I'm completely new to the PSoC and the world of CapSense so please speak slowly and clearly. ;)

         

      I have a Pioneer development kit with the PSoC 4 module (red board) installed (CY8CKIT-042-BLE).

         

      I also have the 'Shield' (CY8CKIT-024 CAPSENSE PROXIMITY SHIELD) for gesture sensing installed along with the jumper as prescribed in, pp 1-2:

         

      https://github.com/cypresssemiconductorco/PSoC-4-BLE/blob/master/100_Projects_in_100_Days/Day044_Proximity_Gestures/ProximityGesturesWithBLE.pdf

         

      I grabbed the project from github here:

         

      https://github.com/cypresssemiconductorco/PSoC-4-BLE/tree/master/100_Projects_in_100_Days/Day044_Proximity_Gestures

         

      When I opened up the Workspace, there were several components that were not up to date (PSoC Creator 4.0 couldn't find them).  So I updated all the components expecting that using the most up-to-date components would be the best route.  A list of components and their original and updated versions is attached.

         

      The program builds and loads into the PSoC just fine. 

         

      I can power the Pioneer board and I can pair and 'connect' the evaluation board with BLE to a PC running Windows 10 Pro. 

         

      I can not, however, get any gestures to do anything when looking at a gallery of photos..

         

      I am also not observing the LED illumination on the Shield as described in both the literature and shown in the video.

         

      I suspect that there is an issue reading the Shield, but I have made several attempts to 'debug' so I can see what the code is doing, but have not been successful.

         

      The information in the Output pane reads as follows:

         

      Device 'PSoC 4200 BLE CY8C4247LQ*-BL483' was successfully programmed at 11/15/2016 11:22:15.
      Continuing target program
      =thread-group-exited,id="i1"
      Error: dbg.M0015: Debugger exited unexpectedly during run.  Encountered error (Target disconnected See output window for more information.)

         

       

         

      PSoC Creator is running on W7 Pro 64-bit.

         

      The Pioneer board is powered from the W7 PC via USB.

         

       

         

      A) Has anyone out there had recent (2016) success with the Proximity Gesture Code in the PSoC 4 on the Pioneer board using PSoC Creator 4.0?  If so, what did you do to make the project function?

         

      B) Any pointers on how to get into a debug session?

         

      Thank you in advance for your time,