- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there Orcad Symbol available for CY7C2663KV18-450BZI.
Also I read in the forum that address pins can be assigned in any order as per the document in the post below.
http://www.cypress.com/file/56341/download
But this document also talks about the special case where A0 and A1 must be in the same location on both SRAMs. This case occurs when the application is using the internal Burst Counters.
This is not applicable for CY7C2663KV18-450BZI RAM I hope as there is no A0/A1 pin marking on the ball out.
Please confirm.
Regards,
Abishek
Solved! Go to Solution.
- Labels:
-
SYNC
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Abhishek,
Regarding the address pins please refer the KB article from the link given below:
ORCAD symbol is not readily available.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Abhishek,
Regarding the address pins please refer the KB article from the link given below:
ORCAD symbol is not readily available.
Thanks.