7 Replies Latest reply on Nov 22, 2016 1:54 AM by jobi

    Programming requires I select the device every time

    bnichols_1926576

      Hello,

         

      I am using PSOC Creator 3.3 with the CY8Ckit-050. I believe some setting or something has gotten changed but I cannot figure it out. The problem is: When I used to click the program button PSoC would program the device plugged into my computer without any further intervention. However, now when I click the button it brings up the "Select Debug Target" window and I have to press "Port Acquire" and then connect and finally the Ok button for programming to happen. This is a bit of a nuisance because I am cosntantly programming the device while I am developing my program.

         

      Have I changed a setting somewhere? Honestly, I don't believe this to be the case as I have not been mucking around in any settings windows.

         

      Thanks for any help.