6 Replies Latest reply on Dec 4, 2016 11:19 PM by lukasakerlund_1537441

    Kitprog can't detect target on my design

    lukasakerlund_1537441

      Hello,

         

      I am testing out my new design with a  CY8C5688AXI-LP099, and I'm trying to connect with a kitprog, snapped off a CY8CKIT-059.

         

      But I'm getting "FAILED! Can not acquire device in SWD mode!" i PSoC programmer 3.25. I can detect the kitprog and have upgraded firmware. The gnd, swdio, swdclk and rst are connected to the kitprog, I'm powering the board from an USB charger.

         

      Any ideas?