Attachments are accessible only for community members.
Anonymous
Not applicable
Dec 14, 2016
07:16 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 14, 2016
07:16 AM
I'm trying to upgrade my KitProg to the newest version. I'm using the PSoC programmer, clicking upgrade firmware, unplugging then replugging. It goes through the upgrade and reports a success, but then reports the same firmware version. Has anyone had this issue? I attached the programmer output.
3 Replies
Dec 20, 2016
11:25 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 20, 2016
11:25 PM
Hi Brendan,
Could you please tell me which Kit are you using ? Could you try doing it in another system ? We just want to confirm whether it is a software issue or a hardware issue ?
Best Regards,
VSRS
Dec 21, 2016
06:39 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 21, 2016
06:39 AM
I was using the PSoC Pioneer 4000 kit.
Dec 21, 2016
11:34 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 21, 2016
11:34 PM
Hi Brendan,
Could you please try updating from another system with PSoC creator installed? Just want to confirm whether it is a software issue.
Best Regards,
VSRS