As the subject says, I would like to know how I could possibly disable the shield pin of my capsense module if a specific pin is pulled low. Right now I have my capsense module and a Digital Input pin with the following settings.
Type: Digital Input, HW connection.
Drive mode: Resistive pull up
Initial drive state: High (1)
In the end I would like my project to test if the Digital Input pin is pulled low and if it is low I would like it to disable the shield pin of the capsense module. How would I go about doing this in code?
Please specify the CapSense component version as well as the CapSense configuration of your project , i.e. is shield a separate electrode or just applied to the sensors?, what sensing modes are in a design, etc.?
If possible please attach your project here.