- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Everyone,
I recently had to re-install PSoC Creator 4 (s4.0.0.432). Now when I go to create a new project, I get the option to select either "Code Example" or "Pre-populated Schematic". The option to create a new blank project seems to have disappeared. I thought maybe the install was corrupt, so I re-downloaded the setup file and did a typical install again and I still have the same issue. (FYI: I did not have this issue when I had originally upgraded from PSoC Creator 3 to 4.)
What am I missing or doing wrong?
Thanks.
-Brian
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I get the 'empty schematic' option on the second page of the wizard when I select 'target kit' or 'target device' on the first page. Its not there though when I selected 'target module', for some reason.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I get the 'empty schematic' option on the second page of the wizard when I select 'target kit' or 'target device' on the first page. Its not there though when I selected 'target module', for some reason.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi hli,
Thanks for the reply.
You are correct in that this problem is dependent on what target I pick. I have been working with the PRoC BLE (which is showing me the issue), but when I select PSoC 4200BLE, I get the option for an "Empty Schematic". Weird.
-Brian
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You should raise a support case with Cypress, so they can fix it in one of the next Creator version.