- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am having CY8CKIT-042-BLE and want to interface Adafruit Neopixel ring(Data sheet attached below) with it, as per datasheet I need to generate delay of minimum 300 nanoseconds using timer, but timer doesn't give exact delay when used at high frequency(above 1Mhz).
I also downloaded project created by Mark Hasting for CYBL10563 as well as CY8C4247LQI but it pops me error as "Component 'StripLights' uses component 'cy_clock_v2_10' in its implementation. 'cy_clock_v2_10' has an error: The cy_clock_v2_10 component (StripLights_HFCLK) is not compatible with the selected device. Please check the component datasheet for details on updating to a compatible component."
Please guide me to overcome above error so that I can use "StripLights" block in my project.
Also I had updated my PSoC creater to version 4.
Please help
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Duplicate post. Please follow up here: http://www.cypress.com/forum/proc-ble/how-create-300-nanoseconds-proc-ble-using-timer
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Duplicate post. Please follow up here: http://www.cypress.com/forum/proc-ble/how-create-300-nanoseconds-proc-ble-using-timer
Bob