1 Reply Latest reply on Mar 8, 2017 6:20 AM by howe

    FM4-176L-S6E2CC Pioneer Kit Documentation Error

    david.waldo_1638991

      This is my first post to the forums.

         

      I think I have found an error in the FM4-176L-S6E2CC Pioneer Kit Documentation. I am not sure if I am reading this correctly or not.

         

      Here is where I got the documentation for my board since I have the FM4-176L-S6E2CC-ETH Pioneer Kit:

         

      http://www.cypress.com/documentation/development-kitsboards/fm4-176l-s6e2cc-eth-arm-cortex-m4-mcu-starter-kit-ethernet-and

         

      If you look at the starter kit document: FM4_AN709-00010 Revision 1.1 it says that the Arduino interface has CN9-Pin 1 and CN9-Pin 2 attached to pin numbers 107 and 106 respectively. However, if you look at the schematic diagram (sheet 6) on the same web page, it shows the CN9-Pin 1 and CN9-Pin 2 attached to pin numbers 109 and 110 respectively.

         

      I have set up the UART12 TX for SOT12_0 and have verified that it works using those pins. Am I correct that the Pioneer Kit document has an error or am I missing something?