Anonymous
Not applicable
Mar 02, 2017
05:35 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 02, 2017
05:35 PM
I just designed in a CYBLE-014008-00 on a 5V supply, and I haven't been able to recognize the device in PSOC Creator. After confirming my pin connections over and over again, I was trying a few things and found that it WOULD recognize the device if I used a 3.3V supply on this. Has anybody else seen this? / How can I get it to work with my 5V supply? Thanks.
Labels
1 Reply
Mar 05, 2017
11:06 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 05, 2017
11:06 PM
Hello,
1)Are you using a Development Kit?
2)If not, how are you connecting the device to the System, are you using miniprog3?
3)Please let us know the Settings in PSoC Creator > Tools > Program/Debug > Port Configuration.
4)Please have a look at the document:http://www.cypress.com/knowledge-base-article/troubleshooting-psoc-345lp-programmingdebugging-issues...
Thanks,
Hima