4 Replies Latest reply on Mar 11, 2017 3:31 AM by info_1957421

    Inverted Output on TCPWM (STOP) not work

    info_1957421

      Hello,

         

      I have problems to setup a TCPWM with inverted Output.

         

      I selected in PWM/Output line signal: Inverse output and when PWM is running the Signal is inverted.

         

      But when I stop the PWM Port Pin goes LOW, but I need HIGH (also Inverse).

         

      Also tried with Output line_n signal (Direct output/Inverse output), but still the same on Stop Port Pin is LOW.

         

      Pull-up Resistor activated still also has no effect.

         

      Regards,

         

      Michael