Anonymous
Not applicable
Mar 16, 2017
05:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 16, 2017
05:54 AM
the inputs of OPamps(CTBm block) in analog blocks usually is P1(*), P2(*), unfornately our PCB layouts at P3(7).TRM and other documents shows the inputs can also be AMUXBUS A or B, then connects to 3(7). How to configure it?
Always have analog routing error during the compiling.
Solved! Go to Solution.
Labels
- Labels:
-
BLE
1 Solution
Mar 16, 2017
10:27 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 16, 2017
10:27 AM
If you are using the Pioneer base board to plug into. P3.7 is connected to the Blue led and that is why you are getting the Routing error.
2 Replies
Mar 16, 2017
09:29 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 16, 2017
09:29 AM
Please post your code so we can check it. What chip ?
Mar 16, 2017
10:27 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 16, 2017
10:27 AM
If you are using the Pioneer base board to plug into. P3.7 is connected to the Blue led and that is why you are getting the Routing error.