- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All,
I would like to control GPIO pins on CY8CKIT-042 which used CY8C5868LTI-LP039 as its controller.
I used C# software and SWD protocal could program PSOC4.
Is there any dll or library that I could use my software to control GPIO(P5LP3_6/P5LP3_7)?
Many thanks for your help.
Ben
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome in the forum, Ben.
Preferred way is to use Cypress's IDE named Creator to control any of the >100 components. Download from here.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bob,
Thanks.
Since I only need to control 2 wires, Creator is too complex for me.
Ben
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Perhaps you have a PSoC® 4 CY8CKIT-049 4xxx Prototyping Kit
Then you can use the command
Int32_t CySetGpioValue (uint32_t handle);
Int32_t CyGetGpioValue (uint32_t handle);
From cyusbserial.dll
Little more: CY8CKIT-049, USB-Serial CY7C65211 use as an I2C master.