Apr 04, 2017
12:44 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 04, 2017
12:44 AM
Hello,
I am using a PWM component to generate a signal around 40 kHz on one pin.
However, I don't need a continuous signal, I need instead a signal every minute or so (triggered by software) of only 1-32 pulses.
Now I wanted to use a counter and use the PWM signal a trigger for the counter, but the counter doesn't like the signal as clock input.
What I can do about it?
Mark
Labels
- Labels:
-
PSoC 5LP
3 Replies
Apr 04, 2017
02:39 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 04, 2017
02:39 AM
Just configure the counter as UDB and use it as in the attached picture.
Bob
Apr 05, 2017
06:04 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 05, 2017
06:04 PM
Thanks, Bob, this was what I am looking for, will try it out...
Mark
Apr 06, 2017
02:45 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 06, 2017
02:45 AM
You are always welcome, Mark.
Bob