2 Replies Latest reply on Oct 11, 2017 10:01 PM by yuva

    Cyalkit E02 firmware not complete?


      Hi to all,


      from the p.31 of Cyalkit e-02 solar powered BLE sensor RDK guide section 3.4, the Serial Command List states that there is the ability to configure basic Eddystone parameters. By using the solar_BLE_sensor_v1.100.hex firmware it seems that only a portion of the commands recognized ([1] -[5] and [19] - [22]). Is this normal? Am i supposed to perform a special procedure in order to "unlock" the eddystone configuration service from USB?


      thanks in advance