Anonymous
Not applicable
May 09, 2017
05:06 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 09, 2017
05:06 AM
Hello there!
I have a problem with the USBUART component of psoc 5. I am sure that the serial communication is working properly when the COM is open (with open I mean that I have a SERIAL monitor open on the PC), but the whole code is stopped when the COM monitor is not open. So basically I have a perfect communication when the PORT is open, however when I close it everything is stopped.
I would find a function which allows me to send data to the PC only when the communication "is open", thus allowing the code to run along while the COM port monitor is not open on the PC.
Any suggestions?
Thanks,
Matteo
Labels
- Labels:
-
PSoC 5LP
1 Reply
May 10, 2017
10:24 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 10, 2017
10:24 PM
The information asked is given in this KBA-