I am still just doing the lessons from the PSOC 101, and i am stuck at I2C, Bridge Control Panel does not list my device.
I ve tried all ports available in cydwr.
The 2x6 female header for the debugger does seem to provide dedicated I2C Pins.
I noticed after some re-read of sparkfuns intro that there are I2C jumpers. Is this the solution?
I soldered the jumpers and set the
EZI2C_Slave pin sda ---> P6.1/A4/SCL
EZI2C_Slave pin scl --> P6.0/A5/SDA