2 Replies Latest reply on May 15, 2017 11:49 PM by 1065271400_2323246

question about data file

1065271400_2323246 Aug 18, 2017 12:56 PM

hello,everyone,

I transfer several data to the pc,and I use the "control center" to do this,but when I open the file ,it shows some error codes?Is it ASCII code or string ? Does it show the data correctly ? Or does it only show in this way?Thank you!

regards,

Alex

1. Re: question about data file

manaskantd_51 May 15, 2017 10:32 PM (in response to 1065271400_2323246)

Hi Alex,

The Control Center stores the hex values coming form FX3 as is into a file. You can open the saved file using any hex editor software and you should be able to see the data sent by FX3.



Thanks
Manas
Like Show 0 Likes(0)

Actions
2. Re: question about data file

1065271400_2323246 May 15, 2017 11:49 PM (in response to manaskantd_51)

ok,thank you very much ,Manas
Like Show 0 Likes(0)

Actions

Go to original post