5 Replies Latest reply on May 25, 2017 9:46 PM by DheerajDake

    EZ-Serial firmware not displaying any boot events on reboot - CYBLE-012011

    DheerajDake

      Hello, 

         

      I have flashed the EZ-Serial image onto my CYBLE-012011 evaluation board from here. I connected USB-UART to pins P3.4 and P3.5. I opened the COM port on putty and did a RESET(shorted XRES to ground ). According to the firmware guide in here(page 8), the factory default behaviour should give a boot message like 

      @E,0032,BOOT,E=0100,S=030100C2,P=0100,C=01,A=00A050E3835F 

      But I am not seeing any output on the COM port. Also the guide says that local echo is enabled. I can't see anything being printed on the console when I type in. How does this work?

      Thanks
      Dheeraj