- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am in need of a a USB cable solution that would let me use an old CY3672B unit on USB. I assume the "USB" version of the programmer just used a USB->parallel adapter cable as I see signs of FTDI FTD2XX drivers in the software. Might there be a commonly available "USB printer" cable based on the FTDI chip that would work?
Alternately I can probably get by with an old version of the CY3672 programmer software that works with parallel ports on WinXP if I absolutely had to.
thanks,
Steve
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It turns out if you install the current version of the software on Windows XP, it will still run the parallel port programmer if you do not have the USB programmer.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It turns out if you install the current version of the software on Windows XP, it will still run the parallel port programmer if you do not have the USB programmer.