0 Replies Latest reply on Jun 18, 2017 10:31 PM by dharmadhikaridhananjay_2548096

    configuration of cypress mbr3116 using  host controller renesas

    dharmadhikaridhananjay_2548096

      I want to configure cypress mbr3116 using i2c protocols by using host controller Renesas R8C25276. The host is writing data in memory of cypress but after giving command of Save_Check_crc & Reset_sw it is going in low power state mode. I have given wake up instruction to wake up the device &  The delay between two i2c transaction is also less than 320ms. Host is reading data correctly after sending commands but its not working. Is there any other parameters i need to check?