Romain, I thought we had addressed all these issues in 4.1.
Do you have an open support case?
Not wanting to hijack this thread, but I do not have a support case. I'm happy to open a new thread to describe the issues if that can help.
The attached project generates the error shown below when built with Creator 4.1. The issue seems very similar to the one discussed here. Removing the op-amp or using only two inputs on the SAR allows the build to complete without errors.
I created case 00399933 and received a reply saying to post in the community forum.
I have two questions:
1) Is this the same issue discussed in the link above, or is this some other problem with Creator 4.1?
2) Is there any work-around specifically for the attached design? The board containing this design is already built.
Error: plm.M0046: E2713: <Pin_Source(0)> cannot be placed at <P1> because the location does not support the required features: <ROUTABLE>.
Error: plm.M0046: E2055: An error occurred during placement of the design.
Error: plm.M0046: "C:\Program Files (x86)\Cypress\PSoC Creator\4.1\PSoC Creator\bin/sjplacer.exe" failed (0x00000001)
The components have been updated and I think that is the issue. If you unlock all the pins and have the design find the correct pins it works. This happens sometimes. This would require a new PWA or you using the old software for this design.
a picture is worth a thousand words, thanks.