I guess the question is what ribbon cable connector would mate with a HEADER FEMALE 24POS .1" DL AU Sullins Connector SFH11-PBPC-D12-ST-BK?
That is the female connector that is already on the board.
I did find some cable-end connector pigtails that I can use to connect to my device for prototyping:
I have successfully used the following through-hole shrouded/keyed male headers on a custom board intended to support the CYBLE-xxxxxx-EVAL plug-in modules:
- https://octopart.com/search?q=D2520-6002-AR (2x10-pin side)
- https://octopart.com/search?q=D2524-6002-AR (2x12-pin side)
These may not be as good as the cable-connected ones that you found, but they are great for PCBs.
If you contact Sullins they will give you part numbers that match the module connectors in IDC . Maybe even a free samples.