Jul 09, 2017
11:42 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 09, 2017
11:42 PM
Hello,
I was using CY8CKIT-044 Psoc 4 M-Series Pioneer kit . By mistake CY8C5868LTI-LP039 got burn and now i can not able to program and read through USB to CY8C4247AZI-M485 IC .
Is it any possibility to fix this board if i change CY8C5868LTI-LP039 IC ?
Require firmware for CY8C5868LTI-LP039 to make clone as previous ?
Note- I have MiniProg3 to flash again CY8C5868LTI-LP039 , but i don't have firmware file ?
Best Regards
Deepak Aagri
Solved! Go to Solution.
1 Solution
Aug 01, 2017
05:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 01, 2017
05:02 AM
3 Replies
Aug 01, 2017
04:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 01, 2017
04:21 AM
The firmware for the kitprog is not shared. So it will not be possible.
Aug 01, 2017
05:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 01, 2017
05:02 AM
Aug 08, 2017
11:20 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 08, 2017
11:20 PM
Yeah, Restore PSoC 5LP using MiniProg3 section can be used I guess. I was thinking as the PSoC5 he has is not bootloadable,it will not be possible.