- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
My board - Murata Type1LD
I try to run test with command : pkteng_start 00:11:22:33:44:55 tx 20 1024 0
The last 0 mean that this test not stop.
In my setup I see the Current and when this command run the current increase to be 11 mA, but after a short time the current return to 3 or 4 mA.
I see the measurment current in my lab power supply/
I use Murata document -added.
Solved! Go to Solution.
- Labels:
-
FM4_MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What is the command sequence that you are using here before running pkteng_start command? Is this running with the mfgtest or the production version of the firmware?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What is the command sequence that you are using here before running pkteng_start command? Is this running with the mfgtest or the production version of the firmware?