Wireless
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hello,
After having read the post "How to Debug CYBT343026EVAL with Modus " I expect that it is possible to use MiniProg4 to debug a CTBT-343026 eval board. I am in the configuration given below :
1- Modus toolbox Version: 2.2.0 Build ID: 2181
2- debug tool "CY8CKIT-005 MiniProg4 " with the configuration given by "Cypress programmer" :
Info : Connected - MiniProg4 CMSIS-DAP BULK-1F1C15C800287400 FW Version 2.10.878
Info : Selected Device: MP4 BULK-1F1C15C800287400
Info : Could not connect to device: MiniProg4/PSoC 61/62/63
Info : Open On-Chip Debugger 0.10.0+dev-3.0.0.665 (2020-03-20-10:13)
3 - Connected to "CYBT-343026-01" as show in the give the attached picture.
4- I have take project "HAL_PUART" given in the "project example creator" and change "ENABLE_DEBUG?=1" build all and flash
I am trying to use MiniProg4 for debugging and IDE is reporting an error (see attached error picture). Does anyone already encounter this problem ?
Thank you in advance for your support
- Labels:
-
Wireless
WinstonF_61
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hi,
In the connection diagram it looks like you the USB port for the EVAL board connected to a PC. In that case the USB UART on the EVAL board will be connected to the CYBT-343026 via the HCI UART. I looked at 'connection.jpg' and it seems like, you may want to change all switches on the 'SW4 - HCI UART' to 'OFF' to disconnect the on board USB UART, to avoid any signal clashes.
Let me know if this helps.
Regards
Winston.
Winston
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hello Winston and thank you very mutch for your help !
Change all switches on the 'SW4 - HCI UART' to 'OFF' doesn't solve the problem.
I have change the connector to make sur that the default is not from it and the problem is still present. has anyone use MiniProg4 on CYBT-343026-01 ?
Best regards
SheetalJ
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hi @sylvain_77176 ,
We were able to reproduce this issue on our side. I will update you soon after investigating more on this error.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hello,
Thank you very much for your help. Do you think it will take a lot of time to investigate ?
Sorry to rush you but I am on a project with very short milestone.
Regards
